Repair of Donggo Feeder Voltage with the Power Evacuation Method to the Substation at PT. PLN (Persero) ULP Woha
Keywords:
Power Loss, Voltage Drop, Power EvacuationAbstract
In the distribution network, there is one problem, namely the rating capacity that exceeds the feeder load and the length of the feeder. This will cause the current distributed by a conductor to be greater and the distance of the load served is too far so that it can cause power losses and voltage drops to customers. One way to overcome the problem of overloading the feeder is to perform power evacuation. Based on the results of the study, it shows that at PT. PLN (Persero) the Donggo Feeder experienced a voltage drop at the end voltage. One of the causes of the end voltage drop is the length of the electrical system circuit from the source. One solution to this problem is to perform power evacuation. In this case, the working principle of power evacuation is to build a new feeder to increase the voltage. By carrying out this power evacuation, it has a good impact on improving the end voltage at the feeder load, where the end voltage drop must follow the standard, namely a minimum limit of +5% and -10% set by PT. PLN (Persero) in the standard voltage (SPLN No. 72,1987).
References
Muhammad, Yasyfin N. 2022. Perbaik Tegangan Penyulang Karumbu Dengan Metode Pecah Beban Pada PT.PLN (Persero) ULP Woha. Teknik Elektro Universitas Teknologi Sumbawa.
Pranata, F., Taufiq., Jannah, M. 2023. “Perbaikan Susut Teknis Dan Nilai Tegangan Ujung Jaringan Tegangan Menengah Pada Penyulang TP-01 Studi Kasus ULP Tanjung Pura”. Jurnal Energi Listrik.
Nasution, Fitria E. 2023. ANALISA PERBAIKAN JATUH TEGANGAN PADA PEMASANGAN GARDU SISIPAN PW04 LONGKIB SUBULUSSALAM KOTA. Teknik Elektro Universitas Pembangunan Panca Budi Medan.
Ramadhan, R., Lesmana, D., Tharo, Z. 2024. “Penurunan Drop Tegangan Penyulang 20 kV Dengan Metode Pecah Beban”. Teknik Elektro Universitas Pembangunan Panca Budi Medan.
Pratama, Renaldi Bayu., Wibowo, P., Anisah, S. 2025. “Analisis Pengaruh Penggantian Konduktor Pada Saluran Udara Tegangan Menengah 20 Kv Terhadap Drop Tegangan di PT.PLN (Persero) UP3 Bangkinang”. Teknik Elektro Universitas Pembangunan Panca Budi Medan.
SPLN 72:1987. Spesifikasi Desain untuk Jaringan Tegangan Menengah (JTM) dan Jaringan Tegangan Rendah (JTR).
Anisah, S., Rahmaniar., Khaizairani, A., 2018. ANALISA PERBAIKAN TEGANGAN UJUNG PADA JARINGAN TEGANGAN MENENGAH 20 KV EXPRESS TRIENGGADENG DAERAH KERJA PT PLN (PERSERO) AREA SIGLI RAYON MEUREUDU DENGAN SIMULASI E-TAP. Teknik Elektro Universitas Pembangunan Panca Budi Medan.
Fauzi, Muhammad Iqbal. 2018. STUDI SUSUT TEGANGAN DAN RUGI DAYA PADA JARINGAN DISTRIBUSI SEKUNDER PADA TRAFO DISTRIBUSI SB-01 PT PLN (PERSERO) RAYON SIBORONGBORONG. Teknik Elektro Universitas Pembangunan Panca Budi Medan.
International Conferance Of Digital Sciences And Engineering Technology , Education and Science, its website, and the articles published therein are licensed under a 
